Mopar 68096438AJ Park And Turn Headlamp

Remove the six push-pin clips, then remove the plastic shield from the top of the radiator. Remove the top headlight mounting screw. For access to the upper screw, remove the radiator top cover, then use a magnetic socket with a long extension to remove the vertical screw. Other components are removed here for clarity. Remove the lower headlight mounting screw by reaching a socket and extension vertically between the grille and the radiator core support structure. The screw must not be dropped after it’s unscrewed so you’ll have to use a magnetic socket. If you don’t have one, put some sticky substance such as butyl windshield adhesive or silicone adhesive into the socket to hold the screw. Release the bottom of the tab at the lower section of the access panel to the wheel well splash shield. Open this access door to reach the headlight slide lock. Working through the opening in the wheel well splash shield, move the slide lock upward to disengage it from the rear of the headlight housing. Slide this lock upward to release the headlight housing. Pull the headlight toward the front of the vehicle to pop it loose from the plastic retainer. The ball will pop out of socket when the headlight is pulled forward. Disconnect the wiring harnesses from the headlight, then remove it. Disconnect the wiring harnesses from the rear of the headlight housing. The arrow indicates the headlight adjustment screw. Installation is the reverse of removal.

Yes, fog lights are optional on these vehicles.

Yes, fog lights are optional on these vehicles.

The high intensity zone should be vertically centered with the exact center, about three inches below the horizontal line on the wall.

Remove the plastic shield from the top of the radiator.

Disconnect the wiring harnesses from the headlight and remove it.