Mopar 4892339AA Filter-Engine Oil

Frequent oil changes are essential for preventive maintenance to prolong the life of the engine. It is important to have all the necessary tools and rags or newspapers ready before starting the procedure. Access to the underside of the vehicle can be improved by lifting it on a hoist, ramps, or jack stands. Familiarize yourself with the locations of the oil drain plug and oil filter before starting the oil change. Park the vehicle on a level spot and allow the engine to reach its normal operating temperature before turning it off. Raise the vehicle securely on jack stands and place a drain pan under the drain plug. Remove the plug and allow the old oil to drain completely. Inspect the old oil for any metal shavings or chips. Wipe off the drain plug and clean the area around it before reinstalling and tightening it securely. Move the drain pan under the oil filter and loosen the filter using an oil filter wrench. Wipe off the mounting surface on the block and ensure no old gasket remains. Smear clean engine oil on the rubber gasket of the new filter and attach it to the engine following the tightening directions. For 3.6L V6 engines, lift up the engine cover and remove the filter cap and filter. Remove and discard the old O-ring and insert a new filter into the cap. Apply clean engine oil to the new O-ring and thread the cap into the housing. Remove all tools and lower the vehicle. Add new oil to the engine through the oil filler cap and check the level on the dipstick. Start the engine and check for leaks. Wait for the oil to drain into the pan and recheck the level on the dipstick. After an oil change, check for leaks and proper oil level during the first few trips. Dispose of the old oil properly. To reset the oil change required light, turn the key to the On position without starting the engine and depress the accelerator pedal three times. Turn the key off and start the engine to verify that the indicator message is no longer illuminated.

After completing the oil change process, you should: Lower the vehicle. Add fresh oil through the filler cap. Wait for the oil to drain and check the level on the dipstick. Start the engine and check for leaks. Recheck the oil level and monitor for leaks during the first few trips.

It is important to dispose of the old oil properly. Take it to a recycling center or an auto parts store that accepts used oil for recycling.

To remove the oil filter during an oil change, you should use an oil filter wrench to loosen it.

After draining the old oil and inspecting it for metal shavings, you should wipe off the drain plug before reinstalling it.

After changing the oil filter, locate the oil filler cap in the engine compartment, pour five quarts of fresh oil into the engine, and check the oil level on the dipstick.

After starting the engine briefly, check for any leaks. If you notice any leaks, address them promptly to prevent further issues.

When replacing the old oil filter, reposition the drain pan under the filter, use a filter wrench to loosen and remove the old filter, ensure it’s empty, compare it to the new filter for compatibility, and clean the mounting area on the engine. Apply a light coat of oil to the new filter’s rubber gasket, attach it to the engine following tightening directions, and remove all tools and materials from under the vehicle.

After inserting a new filter into the cap, you should apply clean engine oil to the new O-ring and thread the cap into the housing.

After removing the old oil filter, you should wipe off the mounting surface on the block and ensure no old gasket remains.